Cart 0
Sublimation Rolling Tray

Sublimation Rolling Tray

  • Save $2
Shipping calculated at checkout.
If you want a blank white rolling tray to sublimate on, this is the best one!
  • Print Your Own Design
  • Size: 8" x 5"
  • Material: Polymer


    Pressing Instructions: 

    3D Vacuum Heat Press:
    Press Temperature: 320°F
    Time: 150 - 180 Seconds
        • Attach sublimation transfer paper with image printed in reverse to the tray and then tape down corners with thermal tape
        • Place tray in seal tray inside the press, press needs to be at 320°F, close the seal lid, and press "vacuum" button to vacuum all air out, run your fingers along the inside edge of tray to make sure all air is out and top seal lid element is tight around the tray
        • Close heat press lid and press for the specified temperature and time needed above
        • If the image begins to look blurry, or burnt brown by over-pressing, decrease time by 15 - 30 seconds
        • Once done, remove the tray from the press and remove the transfer paper immediately
        • Allow the tray to cool completely before use

     

    Oven Settings
    Press Temperature: 400°F
    Time: 6 - 10 Minutes
    (test in your oven for accurate time)
      • Attach reversed printed image to tray with thermal tape
      • Wrap silicone wrap around tray
      • Place in oven preheated to 400°F for approximately 6 - 10 minutes (test to determine best timing!)
      • Afterwards, remove wrap and transfer immediately
      • Allow the tray to cool completely before use